Technical Data - B&R Mobile Panel 40 User Manual

6.4.1.4 Technical data

Information:
The following specified characteristic data, features and limit values are only valid for these acces-
sories and may differ from those of the complete system. The data specified for the complete system
applies to the complete system in which this accessory is used, for example.
Model number
General information
Certifications
CE
Functional safety
1)
GOST-R
Keys
Hot plug button
Emergency stop
Connector
Internal connector
2)
Additional connectors
Push-pull connector
Electrical characteristics
Nominal voltage
Nominal current
Power consumption
Operating conditions
Degree of protection per EN 60529
Environmental conditions
Temperature
Operation
Storage
Transport
Relative humidity
Operation
Storage
Transport
Vibration
Operation (continuous)
Operation (occasional)
Storage
Transport
Shock
Operation
Storage
Transport
Mechanical characteristics
Housing
Material
Coating
Cover plate
3)
Material
Dimensions
Width
Height
Depth
Weight
1) Achievable safety classifications
2) For the box cable.
3) The protective cover must be in place when a Mobile Panel 7100, Mobile Panel 40/50 or Mobile Panel 100/200 is not connected.
Mobile Panel 40/50 User's manual V1.80
For connecting the Mobile Panel 7100, Mobile Panel 40/50 or Mobile Panel 100/200
IP65 (only with installed screw plugs, installed protective cover or with con-
nected Mobile Panel 7100, Mobile Panel 40/50 or Mobile Panel 100/200)
Table 62: 4MPCBX.0000-00 - Technical data
(safety integrity level, safety category, performance level) are documented in the user's manual (section
4MPCBX.0000-00
Yes
Yes
Yes
1 button, 2 normally closed contacts
1 button, 2 normally closed contacts
Key switch or pushbutton
Emergency stop
Enable switch
RS232
Power supply
CAN
Ethernet
Slot ID (monitoring contacts)
Enable switch
Key switch or pushbutton
Emergency stop contacts
Power supply
18 to 30 VDC
150 mA
Approx. 2 W
0 to 50°C
-20 to 60°C
-20 to 60°C
0 to 95%, non-condensing
0 to 95%, non-condensing
0 to 95%, non-condensing
2 to 9 Hz: 1.75 mm amplitude / 9 to 200 Hz: 0.5 g
2 to 9 Hz: 3.5 mm amplitude / 9 to 200 Hz: 1 g
2 to 8 Hz: 7.5 mm amplitude / 8 to 200 Hz: 2 g / 200 to 500 Hz: 4 g
2 to 8 Hz: 7.5 mm amplitude / 8 to 200 Hz: 2 g / 200 to 500 Hz: 4 g
15 g, 11 ms
30 g, 15 ms
30 g, 15 ms
GK-AISi11Mg (gravity die casting)
Powdered RAL 7012, fine structure
GK-AlSi9Mg (gravity die casting)
172.5 mm
158.7 mm
81.7 mm
Approx. 1600 g (without attachment cable)
Accessories
"Safety technology").
113