Table of Contents
Advertisement
PREPARATION FOR STORAGE
The following procedure applies when the machine is
to be stored for a month or more. Store the machine
on flat, level ground, inside a building. If a building is
not available, park the machine in a dry area on
planks and cover the machine with a waterproof
covering. Before storing the machine, carry out the
following operations:
1. Clean the machine.
2. Retract the arm cylinder rod as for as possible
and lower the boom until the attachment is
resting on the ground.
3. Grease the machine thoroughly. The exposed
surfaces of the cylinder rods should be greased
or covered with a protective film. See your
Dealer.
NOTE: When the machine resumes service, the film
will disappear automatically.
4. Drain the fuel tank and fill with a mixture of 90%
diesel fuel and 10% anti-corrosive oil. Run the
engine at idle speed for five minutes to allow the
anti-corrosive oil to reach the lines, filters, pump
and injectors.
5. While the engine is still warm, drain the oil sump,
fill with anti-corrosive oil and replace the engine
oil filter.
6. When the engine is cold, clean the outer parts of
the engine with diesel fuel.
7. Clean or replace the air filter element.
8. Drain the cooling system, leave the drain valves
open and do not tighten the radiator cap.
9. Remove the batteries, clean the battery housings
and make sure not to leave any traces of acid.
Store the batteries in a cool, dry place, where
temperature is always above freezing.
10. Paint any areas where the paint work is not good.
11. Plug the air filter inlet and the exhaust pipe.
12. Remove the starter switch key and place a "Do
not operate" label on the right-hand control arm
and then raise the function cancellation lever
(safety bar in inward position).
13. Lock the hoods and the cab door.
4-20
CHAPTER 4 - OPERATING INSTRUCTIONS
MACHINE STORAGE
PERIODICAL CHECKS
Every month, check:
1. The electrolyte level in the batteries and the
batter y c harge. Recharge the batter ies if
necessary.
2. The grease on the cylinder rods.
3. The fuel level in the fuel tank and the corrosive oil
level in the engine. Add more if necessary.
4. The condition of all lines, connectors and clamps
(rust). Grease if necessary.
5. The condition of the paint work. Apply a coat of
anti-rust treatment where necessary.
Issued 8-04 Bur
6-34551NA
Advertisement
Chapters
Table of Contents
