Case CX75SR Operator's Manual page 72

PDH0248
5. Machine without attachment
Place the machine in line with the trailer, with the
travel reduction gears towards the access ramps.
IMPORTANT: In this position, the travel and
steering controls are reversed.
CS99B518
6. Machine with attachment
When moving from the ramps onto the trailer
bed, raise the boom slightly as soon as the
attachment touches the trailer so as to bring the
machine level and then move forward until the
machine is resting entirely on the trailer.
PDH0249
7. Machine with attachment
4-12
CHAPTER 4 - OPERATING INSTRUCTIONS
Figure 30
Figure 31
Figure 32
When the machine is completely on the trailer,
raise the attachment slightly and swing the
upperstructure so as to bring the attachment
round to the access ramp side.
PDH0250
8. Machine with attachment
Place the machine completely in front of the
trailer so that the attachment and the dozer blade
(if equipped) rest on the floor of the trailer.
PDH0251
9. Machine without attachment
Place the machine completely in front of the
trailer, rotate the upperstructure then place the
dozer blade (if equipped) on the floor of the
trailer.
CS99B519
Issued 8-04 Bur
Figure 33
Figure 34
Figure 35
6-34551NA