REMOVAL
1. Place the bucket flat on flat, horizontal ground.
Operate the attachment controls so that the
arm/bucket linkage pin is not gripped by the
weight of the arm.
2. Stop the engine and remove the starter switch
key.
3. Remove the retaining rings and pins.
CT02D210
4. Remove the bucket pins.
CT02D211
5. Start the engine, disengage the attachment from
the bucket and save the linkage seals for re-use.
CT02D212
6-14
CHAPTER 6 - MAINTENANCE AND ADJUSTMENTS
REPLACING A BUCKET - CX135SR
Figure 37
Figure 38
Figure 39
INSTALLATION
1. Make sure the bucket is in a stable position.
2. Install the linkage seals on the arm bushing
shoulders. Change them if necessary.
3. Start the engine. Extend the bucket cylinder rod
to bring it into its housing. Stop the engine and
remove the starter switch key.
CT02D212
4. Install the arm/bucket linkage pin and then install
the retaining pin and ring.
5. Start the engine. Stop the engine and remove the
starter switch key.
CT02D213
6. Install the connecting rod/bucket linkage pin and
then install the retaining pin and ring.
7. Push the seals back into their housings.
8. Grease the linkage pins.
CT02D210
Issued 8-04 Bur
Figure 40
Figure 41
Figure 42
6-34551NA