B9408252
1. LOAD (LIFT) POINT HEIGHT
2. LOAD (LIFT) POINT RADIUS
3. SWING PIVOT
4. GROUND LINE
5. LOAD (LIFT)POINT ON BUCKET
•
The lift point is the lifting eye on the back of the bucket.
•
The mass of slings and any auxiliary lifting devices shall be deducted from the rated load to determine the net
load that may be lifted.
•
All rated lift capacities are based on the machine being level and on a firm supporting surface. For safe working
loads, the user is expected to make due allowance for the particular job conditions such as soft or uneven
ground, non-level conditions, side loads, hazardous conditions, experience of personnel, etc. The operator and
other personnel should fully acquaint themselves with the operator's manual furnished by the manufacturer
before operating this machine, and rules for safe operation of equipment shall be adhered to at all times.
•
Lifting capacities are in compliance with SAE J 1097/IS 10567.
•
Lifting capacities shown do not exceed 75% of minimum tipping loads or 87% of hydraulic capacities. Capacities
marked with an asterisk (*) are limited by hydraulic capacities.
•
These capacities apply to machines having correct bloomiest cylinder pressure.
•
Least stable position is over the side.
•
Capacities apply only to the machine as originally manufactured and normally equipped.
8-18
CHAPTER 8 - SPECIFICATIONS
LIFTING CAPACITIES
Issued 8-04 Bur
Figure 9
6-34551NA