Installation - Case CX75SR Operator's Manual

INSTALLATION

1. Place the track on the sprocket wheel and on the
side-member.
CS98B246
2. Place the tubes in the notches of the track in
front of the idler wheel.
CS98B247
3. Operate the travel lever of the track concerned in
the reverse travel direction. Stop the movement
when the tubes are pressing against the idler
wheel.
4. Stop the engine and remove the starter switch
key.
CS98B248
5. Place the track on the idler wheel.
6-34551NA
CHAPTER 6 - MAINTENANCE AND ADJUSTMENTS
Figure 15
Figure 16
Figure 17
Issued 8-04 Bur
CS98B209
6. Operate the travel lever of the concerned track to
remove the tubes from the track.
7. Adjust the tension. See Track tension value.
CS98B249
Figure 18
Figure 19
6-7