Bringing The Machine Up To Operating Temperature; Bringing The Machine Up To Operating Temperature - Case CX75SR Operator's Manual

3. Make sure the engine throttle button is in low idle
position. In cold weather, leave it in half-way
position.
CT02C188
4. Insert the starter switch key then turn the key to
the ACC position, the red indicator lamps on the
instrument panel remain illuminated. The audible
alarm device will sound.
CT02C189
5. Turn the starter switch key to the ON position and
hold it there. The preheating indicator lamp
comes on.
IMPORTANT: Do not keep the starter switch key in
the preheating position for more than 6 seconds.
CT02D268
6-34551NA
CHAPTER 4 - OPERATING INSTRUCTIONS
Figure 2
Figure 3
Figure 4
Issued 8-04 Bur
6. Turn the starter switch key to the START position.
Release the key as soon as the engine starts to
turn. If the engine stops, wait about a minute and
recommence the operation.
IMPORTANT: Do not operate the starter motor for
more than 20 seconds at one time. Do not operate
the starter motor when the engine is running.
IMPORTANT: When the engine is running, let it heat
up until the low idle mode is steady.
IMPORTANT: When the engine is running, check the
indicators and lights on the instrument panel
regularly.
CT02C191
7. Lower the function cancellation lever.
CT02C192
BRINGING THE MACHINE UP TO
OPERATING TEMPERATURE
IMPORTANT: Normal operating temperature of the
hydraulic fluid is between 50°C and 80°C (122° -
176° F) in the middle of the temperature indicator. If
the machine is used with the hydraulic fluid at a
temperature below 20°C (68° F) then damage can be
caused.
After star ting the engine and before using the
machine, wait till the temperature of the hydraulic
fluid reaches 20°C (68° F).
Figure 5
Figure 6
4-5