Starting Up After Storage - Case CX75SR Operator's Manual

STARTING UP AFTER STORAGE

1. Close the drain valves and fill the cooling system.
2. Drain the fuel tank and fill with clean diesel fuel.
3. Drain the engine sump, fill with clean engine oil and check the oil level.
4. Change the fuel filter.
5. Install the batteries.
6. Grease the machine thoroughly.
7. Check the condition of the fan drive belt and replace it if necessary.
8. Check the hydraulic fluid level and add more fluid if necessary.
9. Check the travel reduction gears oil level and add more oil if necessary.
10. Clean the cylinder rods.
11. Unplug the air filter inlet and the exhaust pipe.
12. Remove the "Do not operate" tag and start the engine, following the starting up procedure.
13. Keep a careful watch on all systems display panel lamps and indicators.
WARNING: Check the machine for leaks or for any parts that are broken,
!
defective or missing.
WARNING: Before starting the engine, make sure that all controls are in
! neutral position. This prevents the machine from moving unexpectedly or
an electrical appliance from starting up.
WARNING: Avoid running the engine in a confined place. Make sure there
!
is adequate ventilation at all times.
6-34551NA
CHAPTER 4 - OPERATING INSTRUCTIONS
Issued 8-04 Bur
4-21