SERVICE SPECIFICATIONS
Oil level check....................................................................................................................................Every 250 hours
Draining .............................................................................. Every 1000 hours (after the first 250 hours of operation)
Oil capacity ...................................................................................................................................... 2.50 liters (.7 gal)
Oil type ............................................................................................................................... See Fluids and lubricants
LEVEL
1. Park the machine on flat, horizontal ground.
2. Move the machine so that plug (1) is in the lowest
possible position.
CT02D007
3. Stop the engine and remove the starter switch
key.
4. Remove the plug (2) and check the oil level. The
level must come up to the lower edge of the
orifice. If required, top up through this port (2)
until oil comes up to the bottom edge of the port.
5. Install plug (2).
6. Repeat Steps 2 to 5 for the other travel reduction
gear. Travel slowly with the machine and make
sure there are no leaks.
2
CT02D142
DRAINING AND REFILLING
1. Park the machine on flat, horizontal ground.
6-34551NA
CHAPTER 5 - LUBRICATION, FILTERS, AND FLUIDS
TRAVEL REDUCTION GEARS - CX135SR
1
Figure 142
Figure 143
Issued 8-04 Bur
2. Move the machine so that plug (1) is in the lowest
possible position.
CT02D142
3. Shut down the engine and remove the starter
switch key.
4. Place a receptacle of a suitable capacity under
the travel reduction gear and remove the two
plugs (1) and (2).
5. Allow the oil to drain.
IMPORTANT: Check the condition of the drained
oil. If it contains metal filings or foreign matter,
see your Dealer.
6. Install the plug (1), fill with oil through the port (2)
until oil comes up to the bottom edge of port (2),
then install plug (2).
7. Repeat Steps 2 to 6 for the other travel reduction
gear. Travel slowly with the machine and make
sure there are no leaks.
2
CT02D142
1
Figure 144
1
Figure 145
5-49