Test Scale / Load Scale; Brix Scale - Ametek Reichert AR5 User Manual

Instructions for Use
(continued)
PC Program Config
(continued)

Test Scale / Load Scale

At Test you can test your new generated scale. Type in an Input Value for a known refractive index. At the
field below, the actual temperature is required. If you click Calculate, the Scale Result will be computed.
Figure IS-21, Test New Scale
If you click LOAD, you can load a pre-generated scale on your device. By pressing the SAVE button you
are able to store a generated scale on your PC.

Brix Scale

The Brix Scale is pre-defined on your device. Because of this fact you can't edit the coefficients. The other
values can be changed by the user for individual configuration. Min. Input Value signifies the smallest
input parameter, the same goes for Max. Input Value. Within the limits of Min. Temperature and Max.
Temperature correct scale values could be computed. Format Length and Decimal Places allow you
to set the resolution of the scale. The coefficients result from the measurements with known samples and
were provided to you by Reichert.
Figure IS-22, Brix Scale
1400700-101 Rev. A
31