Table of Contents
Advertisement
Transducer cable
If the transducer is removed from the hull unit while installing the hull unit, reattach the
transducer and route the transducer cables as shown in the following figure.
Route the cables so their lengths are as indicated in
the figure below.
Failure to observe the lengths may damage or sever
cables.
Cable tie
Max.
100 mm
150 mm
Cable clamp 1
Mounting orientation for cable clamp 1
The largest hole of the clamp must be oriented
to the left.
Torque
2.40N•m
Upset head bolt
(M5×30, 4 pcs)
NOTICE
Cable tie
100 mm
Cable clamp 1
Cable fixing rubber
FSV-753 (800 mm travel):
830 mm
*
FSV-754 (1100 mm travel):
*
1030 mm
*
Tolerance: +0 mm, -20 mm
Cable clamp 2
Cable fixing rubber
Mounting orientation for cable clamp 2
Cable clamp
Measurement end position
Max.
150 mm
Measurement start position
Cables must be routed with
the thickest cable farthest out.
The largest hole of the clamp must be oriented
to the right.
Cable clamp
Torque
2.40N•m
Upset head bolt
(M5×30, 4 pcs)
2. WIRING
Top view
2-3
Advertisement
Table of Contents
