Table of Contents
Advertisement
2. Remove the four binding screws (M5×12) from the right side of the unit, then insert
the screws to the screw holes for the upset screws that were removed at step 1.
3. Attach the two mounting bases to the right side of the unit, using the upset screws
that were removed at step 1.
(M5×12, 4 pcs)
4. Screw the two mounting screws (M10, supplied) into the lower fixing holes on the
hull unit. Leave 5 mm of thread visible.
5. Set the notches of the unit onto the screws fastened at step 4.
6. Screw the two mounting screws (M10, supplied) into the upper fixing holes.
7. Fasten all screws tightly to secure the unit in place.
Mounting screw
(M10 bolt
Upset screw
1. MOUNTING
Detailed view
Set the notches of the unit to
the screws.
1-31
Advertisement
Table of Contents
