Table of Contents
Advertisement
1.5.2
Bulkhead mounting
1. Remove the two mounting chassis on the bottom of the unit.
Note: Reattach upset screws to the bottom of the unit after removing the mounting
chassis.
Upset screw
6 pcs at each side)
*
: Reattach to the bottom of
the unit after removing the
mounting chassis.
2. Drill six pilot holes in the mounting location for mounting screws (M10 bolts or
coach screws φ10), referring to the outline drawing at the back of this manual.
3. Screw three mounting screws (supplied locally) into the lower pilot holes. Leave 5
mm of thread visible.
4. Set the notches of the unit onto the screws fastened at step 3.
5. Screw three mounting screws (supplied locally) into the upper fixing holes.
6. Fasten all screws tightly to secure the unit in place.
Mounting screw
(M10 bolt or coach
screw Ø10
*
(M8×16,
1. MOUNTING
Mounting chassis
Detailed view
Set the notches of the unit to
the screws.
1-29
Advertisement
Table of Contents
