Table of Contents
Advertisement
1. MOUNTING
1.10.3
Adjusting the tank guide position
If the rollers on the tank guide come into contact with the weld bead on the retraction
tank, rotate the tank guide to adjust the position of the rollers.
1. Lower the transducer manually.
Note: For how to lower the transducer manually, follow the procedure indicated
on the label at the top of the hull unit.
2. Insert four bolts (M10×80, supplied locally) in the holes on the bottom of the tank
guide to push the tank guide rollers inwards.
Note: Steel bolts are recommended to prevent scorching.
3. Remove the four bolts on the bottom of the tank guide and the connected stainless
steel wires.
1-40
Remove four bolts.
Stainless steel wire
Stainless steel wire
Advertisement
Table of Contents
