Table of Contents
Advertisement
5. Attach four bolt hole caps (supplied).
1.4.3
Flush mounting
Note: Be sure the mounting surface is flat.
1. Referring to the outline drawing at the back of this manual, prepare a cutout, then
drill four pilot holes in the mounting location.
2. Attach a ground wire (IV-1.25sq, supplied locally) to the ground terminal at the
bottom of the unit, then connect the other end of the ground wire with the ship's
ground.
*
3. Set the unit to the cutout, then secure the unit with four self-tapping screws
(φ5×20, supplied).
Bolt hole cap
Binding screw
(M5×20, 4 pcs)
Ground screw*
: Use the screw that is preattached to the ground terminal.
(4 pcs)
Ground wire
1. MOUNTING
1-25
Advertisement
Table of Contents
