Table of Contents
Advertisement
1. MOUNTING
5. Unfasten the four hex socket bolts on the top of the main shaft to disassemble the
cable gasket assembly.
6. Unfasten the 16 hex socket bolts to remove the trunnion receptacle from the main
shaft.
7. Rotate the transducer so that the bow mark on the transducer points toward the
ship's bow.
1-14
Note: Transducer cable not shown in this figure.
Hex socket bolt
(M8×25, 16 pcs)
Bow mark
Bow
Hex socket bolt
(M8×25, 4 pcs)
Upper gasket clamp
Gasket clamp
Cable gasket
Gasket clamp
Lower gasket clamp
Trunnion receptacle
Advertisement
Table of Contents
