Table of Contents
Advertisement
3.17.4
[Motion Sensor] menu
You can offset the pitch and roll angle for the motion sensor on the [Motion Sensor]
menu. To display this menu, select [3 Motion Sensor] from the [Installation Setting]
menu.
Note: This setting is only required if the motion sensor is installed separately from the
hull unit.
Menu item
[1 Pitch Angle Correction]
[2 Roll Angle Correction]
3.17.5
[Hull Unit Setting] menu
You can setup information about the hull unit on the [Hull Unit Setting] menu. To dis-
play this menu, select [4 Hull Unit Setting] from the [Installation Setting] menu.
Menu item
[1 REG TD Position]
[2 Middle Key Setting]
[3 Heading Adjust1]
[4 Heading Adjust2]
[5 Hull Unit Stroke]
Menu
Installation Setting
Motion Sensor
1 Pitch Angle Correction
: 0.0
2 Roll Angle Correction
: 0.0
Offsets the pitch angle at the motion sensor.
Offsets the roll angle at the motion sensor.
Menu
Installation Setting
Hull Unit Setting
1 REG TD Position
2 Middle Key Setting
: Fixed Position
3 Heading Adjust1
: 0.0°
4 Heading Adjust2
: 0.0°
5 Hull Unit Stroke
: 800mm
Registers the transducer position. For details, see section 3.3.
Sets the operation when the
pressed.
• [Fixed Position]: The transducer stops at the selected posi-
tion. If the
(mid-protrusion) key is operated the transduc-
er is being raised or lowered, the transducer stops at the
fixed position.
• [Any Position]: The transducer starts lowering when
(Full-protrude) key is operated. The lowering is stopped
when the
(mid-protrusion) key is operated. To raise or
lower the transducer from the current position, use the
(Retract) or
(Full-protrude) key. The
key does not control lowering or raising of the transducer.
Offsets the transducer heading. For details, see section 3.5.
Offsets the motion sensor heading. For details, see
section 3.5.
Selects the stoke (length) of the hull unit ([800 m] or [1100 m]).
3. ADJUSTMENTS
Quit
Remarks
Quit
Remarks
(mid-protrusion) key is
(mid-protrusion)
3-25
Advertisement
Table of Contents
