Introduction
Electrical safety
Safe practices
WARNING
Probes
Peripherals
1-20
Follow these guidelines to minimize shock hazards whenever
you are using the Ultrasound system:
•
To minimize shock hazard, the equipment chassis must be
connected to an electrical ground.
•
The Ultrasound system is equipped with a three-conductor
AC power cable. This must be plugged into an approved
electrical outlet with safety ground.
•
The power outlet used for this equipment should not be
shared with other types of equipment.
•
Both the system power cable and the power connector must
meet international electrical standards
Connecting a Venue 50 to the wrong voltage level will most
likely destroy it.
Follow these guidelines before connecting a probe to the
Ultrasound system:
•
Inspect the probe prior to each use for damage or
degradation to the:
•
housing
•
cable strain relief
•
lens
•
seal
•
connector pins
•
locking mechanism
•
Do not use a damaged or defective probe.
•
Never immerse the probe connector or adapter into any
liquid.
Refer to the Patient Safety Environment section of the User's
Manual for peripheral isolation information.
Venue 50 – Basic Service Manual
5447566-100 English Rev. 7