Power Shut Down; Adjusting The Display Monitor - GE Venue 50 Basic Service Manual

Power shut down

NOTE:
CAUTION

Adjusting the Display Monitor

Venue 50 – Basic Service Manual
5447566-100 English Rev. 7
After truning off a system, wait at least ten seconds before
turning it on again. The system may not be able to boot if power
is recycled too quickly.
Follow these steps to shut down the system:
1. Slightly press the Power On/Off switch once.
2. The System-Exit window is displayed.
3. Select OK.
4. The shutdown process takes several seconds and the
power off sequence is complete when the power status LED
is turned off.
5. Disconnect the probes. Clean or disinfect all probes as
necessary. Store them in their shipping cases to avoid
damage.
DO NOT unplug and/or transport the unit until after the power
off sequence has been completed. Failure to do so may result
in corrupted patient files.
See 'Adjust Brightness' on page 6-3 for more information.
General procedures
4-7