Rf Output Ower Correction Constants (Test 47) - HP 8753D Option 011 Service Manual

RF Output ower Correction Constants (Test 47)

Required Equipment and Tools
ower meter
ower sensor
ower sensor (for Option 006 analyzers)
ower splitter (2)
Attenuator 20 dB
H -IB cable
RF cable 24-inch
Antistatic wrist strap
Antistatic wrist strap cord
Static-control table mat and earth ground wire
Analyzer warm-up Time:
This procedure adjusts several correction constants that can improve the output power level
accuracy of the internal source. They are related to the power level, power slope, power slope
o set, and the ALC roll-o factors among others.
1. If you just completed \Sampler Magnitude and hase Correction Constants (Test 53),"
continue this procedure with step 8.
2. ress
PRESET 5 LOCAL 5
3. ress
ET ADDRE E
LOCAL 5
is 13. Refer to the power meter manual as required to observe or change its H -IB
address.
4. ress
POWER MTR:438A/437
Choose the appropriate model number.
ote
If you are using the H 438A power meter, connect the H 8482A power
sensor to channel A, and the H 8481A power sensor to channel B.
RAFT
3/21/106 15:11
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
0 minutes.
.
Y TEM CONTROLLER
ADDRE : P MTR/HPIB
to toggle between the 438A/437 and 436A power meters.
H 437B or H 438A
H 11667A Option 001
H 8491A Option 020
. The default power meter address
Adjustments and Correction Constants 3-9
H 8482A
H 8481A
H 10833A
H 11500B
H /N 9300-1367
H /N 9300-0980
H /N 9300-0797