Air Liquide SAF-FRO DIGIWAVE II Instruction For Operation And Maintenance page 44

Overflow monitoring threshold low welding current user-defined
Exceeded high threshold monitoring welding current user-defined
Exceeding low threshold current monitoring engine reeling user-defined
Exceeded high threshold monitoring motor current reeling user-defined
Missing for a given device
Communication with a device is very disturbed. Check the connection of
the device.
Do not forget to do a backup of the installation before resetting, because this operation will erase the whole configuration saved in memory. If the reset
DIGIWAVE II
DISPLAY OF THE MESSAGE E82 « U min Detection Process Control »
DISPLAY OF THE MESSAGE E83 « Detection Process U max control »
DISPLAY OF THE MESSAGE E84 « Detection Process Control Reel I min»
DISPLAY OF THE MESSAGE E85 « Detection Process Control Reel Imax»
DISPLAY OF THE MESSAGE E86 « absent Software »
DISPLAY OF THE MESSAGE « Error bus CAN »
If the problem persists, reset the configuration of the generator
does not solve the issue, call After Sales Services.
please make an update generator software
It is imperative to connect and disconnect the device when the system is off
WARNING
44