Air Liquide SAF-FRO DIGIWAVE II Instruction For Operation And Maintenance page 14

Description
The 4T mode implies that the welder can weld without keeping the trigger pressed. He presses and releases the trigger a first time to launch the
welding, then he presses and releases a second time to end the welding.
Option
Configuration > Installation > Cycle :
- Call the trigger program out welding
- Call the trigger program in welding.
MAIN WELDING PARAMETERS SETTING
The welding cycle is actualized with the setting of the main welding parameters.
In the paragraph below, we detail the setting of the main welding parameters:
WIRE SPEED
MANUAL mode:
By placing the cursor on SPEED WIRELESS, pressing OK shows the parameters together to facilitate the adjustment of parameters.
Mode
SYN The wire speed varies in a range settled by the synergy.
MAN The wire speed is not limited by the synergy table.
ARC VOLTAGE
The arc tension is defined according to the regime of arc:
•
flat: average voltage
•
pulsed: choose voltage
Mode
Arc length:
Relative tuning of the arc voltage by ±50 increments around the
SYN
programmed synergic value.
Arc voltage:
MAN
Absolute tuning of the arc voltage during the welding phase.
14
Setting
Unit Interval
Depending of
m/mn
synergy
m/mn [1 ; 25]
Setting
Unit Interval
Increments -50 || +50
Volts -10 || +10
Volts [10 ; 50]
step
0.1
0.1
Step
1
Volts
equivalent
0.2
0.2
DIGIWAVE II