Front Three-Point Lift Linkage - Belarus 3522.5 Operator's Manual

Table 5.2 – Basic parameters и coupling dimensions of FLL
Standard size (configuration)
of the device
Design features
2 Purpose
3 Length of lower drawbars, mm
4 Unblocked Hinged joint width of the upper (lower)
drawbar, mm
5 Diameter of a pin of hinged joint of upper drawbar,
mm
6 Diameter of pin bore of a hinged joint of the lower
drawbar, mm
7 Distance between PTO shaft end extension face
and suspension axis, mm
1)
8 Column height , mm
9 Length of the suspension axis along the collar
mm
10 Lifting power of the device, кН
а) on the suspension axis;
b) at overhang of 610 mm from the suspension axis
_______________________________________________________________________________
1)
Dimension refers to the implement coupling.
2)
It is not allowed to give FLL load exceeding loading of tires specified by loading instruc-
tions set forth in Table 4.3.
Table 5.2а – Information about installation of linkage-mounted ballast weights to FLL
1 Equipment title
2 Primary purpose
3 Design features
4 Type LL (accord. to GOST 10677)
5 Category (accord. to GOST 730-1)
6 Maximum weight of bracket with ballast weights, kg
7 Minimum weight of bracket with ballast weights, kg
8 Weight of bracket without ballast weights, kg
________________________________________________________________________________________________________
1)
Refers to the coupling dimensions of mounted bracket.
Device consisting of three drawbars (upper
one and two lower ones), articulated by the
front ends with the tractor, and by rear ends
with coupling elements of the implement dur-
ing operation
To connect (mount) or coupling of mounted,
and semimounted implements
1)
,
5)
:
1)
1)
247
https://tractormanualz.com/
3522.5-0000010 OM
"LL-2"
775
51 (45)
25
28,7
555
610
825
50
30
Linkage-mounted ballast
weights kit assembled
with a bracket
Additional loading
front driving axis, facilitat-
ing the tractor weight dis-
tribution by coupling to a
tractor lift linkage
It consists of Linkage-
mounted ballast weights
kit assembled with a
mounted bracket
"LL-2"
Category 2
1320
250
160
of