Creeper Control - Belarus 3522.5 Operator's Manual

2.13.3 Creeper control

To switch on the creeper do the following:
а) depress the clutch pedal;
b) stop the tractor;
c) set the gearbox to "0" gear;
d) set the range switching lever 1 (figure 2.13.1) to neutral position;
e) holding the button of the "Braking" mode activation depressed, set the creeper
control lever 2 into position "Snail" (forward along tractor movement);
f) engage a desired gearbox range, and then a desired gear, as specified in subsec-
tions 2.13.1 "Shifting of gearbox ranges" and 2.13.2 "Shifting of gears inside gearbox".
To switch off the creeper do the abovestated operations a), b), c), d). Then holding
the button of the gearbox "Braking" mode depressed set the creeper control lever 2 into
position "Hare" (backward along tractor movement), after that engage a desired gearbox
range and a desired gear.
Ranges and gears within the gearbox are shifted with the creeper switched on in
accordance with instructions of the subsections 2.13.1 and 2.13.2!
ATTENTION: SWITCH ON THE CREEPER ONLY WITH THE TRACTOR
STOPPED AND THE CLUTCH PEDAL FULLY DEPRESSED! IT IS FORBIDDEN TO AC-
TIVATE THE CREEPER AS THE TRACTOR MOVES!
ATTENTION! WHEN THE CREEPER IS ACTIVATED, GEARBOX RANGES "III"
AND "IV" ARE LOCKED, THUS OPERATION WITH THE CREEPER ON IS POSSIBLE
ONLY AT "I" AND "II" RANGES OF FORWARD AND REVERSE MOTION!
50
https://tractormanualz.com/
3522.5-0000010 РЭ