Power Take-Off Shaft End Type - Belarus 3522.5 Operator's Manual

5.6. Power take-off shaft end type

External spline drives (Figure 5.6.1) of the front and rear power take-off shaft (PTO
shaft) of the tractors "BELARUS-3522.5" correspond in design and arrangement to regula-
tory document and standards covering the specified equipment. FPTO shaft and RPTO
shaft ends parameters of the tractor, and also FPTO shaft and RPTO shaft drives specifi-
cations are shown in Table 5.7.
Front PTO shaft is packaged with PTO shaft end of type 2.
Rear PTO shaft is packaged with PTO shaft end of type 1, 2, 3,
The tractor is equipped with PTO shaft end of type 3. The remaining ones shall be
put into the SPTA kit of the tractor.
Table 5.7
FPTO shaft and RPTO shaft
ends and drives parameters
1 Splines lengths L, mm
2 External diameter D
3 Spline quantity, n
4 PTO shaft end rotation fre-
quency, rpm
5 Power transmitted by RPTO
shaft end, kW, not more than
6 Power transmitted by FPTO
shaft end, kW, not more than
7 Type of drive
8 Direction of RPTO shaft end
rotation (see the butt)
_________________________________________________________________________________________
1)
PTO shaft end rotation frequency for economy mode of RPTO shaft
when the rated frequency of the engine crankshaft is 2200 min
Figure 5.9.1 – Power take-off shaft end
Type 1
76
, mm 35
H
6
For rear PTO shaft – 1000 (1530)
60,0
253
https://tractormanualz.com/
Power take-off shaft end type
Type 2
64
35
21
For front PTO shaft – 1000
92,0
44
Independent drive
Clockwise
3522.5-0000010 OM
Type З
89
45
20
1)
185
-1
.