Advertisement
communication
LED status indicators:
H
•
Standby mode—The green LED flashes once per second and the yellow and red LEDs are off.
•
Warm up—The green LED flashes three times per second and the yellow and red LEDs are off.
•
Power on, lamp on or off—The green LED is solid green and the yellow and red LEDs are off.
•
Cool down—The green and yellow LEDs flash three times per second and the red LED is off.
•
Notification—The green LED is solid green, the yellow LED flashes once per second, and the red
LED is off.
•
Non-critical alarm—The green LED is solid green, the yellow LED flashes three times per second,
and the red LED is off.
•
Unacknowledged critical error—The red LED flashes three times per second.
•
Acknowledged critical error—The red LED is solid.
LED status indicators:
I
•
HUB—The LED is green when FPGA video processing is running correctly, orange when FPGA
video processing is not configured, and red when a failure occurs.
•
SMS—The LED is green when the screen management system (SMS) is running correctly, orange
when the SMS or system controller has not booted, and red when a failure occurs.
•
INPUT—The LED is green when FPGA video input is running correctly, orange when FPGA is not
configured, and red when a failure occurs.
•
Power—The LED is green when the low voltage power supply (LVPS) is operating and red when a
failure has occurred. The LED is not illuminated when the LVPS is not on.
Connects the projector to 3D devices.
J
Connects the projector to ingest devices.
K
Connects the projector to input devices with an HDMI connection.
L
Connects the projector to external automation or automation devices.
M
Connects the projector to the touch panel (VGA-Out and Screen Power).
N
Management Ethernet port (10/100/1000 base-T) and connects the projector to USB devices,
O
including the touch panel screen.
Two Ethernet ports connecting the projector to network-attached storage (NAS) devices and the
P
Library Media Server (LMS) network, if applicable. The Media port can also be used for content
transfer.
To display content from a computer, connect it to the projector.
1. To connect the main input card of the projector, connect an Ethernet cable to the Management
Ethernet port on the projector and the other end to your computer.
2. To communicate with the projector, add the projector to the same network as the computer.
For information on connecting devices to the 3D sync terminal, see the "Working with channels" section in the
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe User Manual (P/N: 020-001835-01).
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe Installation and Setup Guide
020-103451-02 Rev. 1 (05-2021)
Copyright
2021 Christie Digital Systems USA, Inc. All rights reserved.
©
Connecting devices to the projector and establishing
26
Advertisement
