Advertisement
Mounting arm
A
Ball joint
B
4. Tighten the mounting arm until it fits tightly on the ball joint.
5. Connect the touch panel harness to the touch panel:
a. Connect one end of the USB cable to the USB port on the rear of the touch panel.
b. Connect one end of the touch panel power cable to the DC IN 12V port on the rear of the
touch panel.
c.
Connect one end of the VGA connector to the VGA port on the rear of the touch panel.
6. Connect the touch panel harness to the projector:
a. Connect the other end of the USB cable to a USB port on the projector communications panel.
b. Connect the other end of the touch panel power cable to the Screen Power port on the
projector communications panel.
c.
Connect the other end of the VGA connector to the VGA Out port on the projector
communications panel.
7. To turn the touch panel on, press the power button on the top of the panel.
If the projector is not connected to AC power, you cannot turn the touch panel on.
The lens seals the projection head, preventing contaminants from entering the main electronics area. Before
installing the lens, ensure that you turn off and unplug the projector.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport the
projector.
1. Remove the lens surround.
2. Turn the lens clamp on the front of the projector to the open position with a hex key.
3. Position the lens so the lens retaining ring mounts align with the lens mount.
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe Installation and Setup Guide
020-103451-02 Rev. 1 (05-2021)
Copyright
2021 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
20
Advertisement
