Advertisement
Learn how to install, connect, and optimize the projector. This section provides detailed information on
projector setup.
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install, or
move the product.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
Before lifting and positioning the projector, refer to the light intensity hazard distance clearance
requirements (on page 10).
1. Position each person at the corners of the projector.
2. Lift the projector and move it to the location where it will be used.
3. Position the projector so it is centered and parallel with the theater screen. If space is limited, aim the
projector slightly off-center and use lens offset to center the image on the screen.
To ensure optimum performance, install the projector so it is centered and parallel with the screen. To
compensate for tilt or offset, you can adjust the projector feet and the lens mount position.
The front-to-back tilt of the projector must not exceed 15°.
1. To adjust the height of the projector, loosen the lock nut on the adjustable feet on the bottom of the
projector.
19 mm (0.75 in.) wrench
A
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe Installation and Setup Guide
020-103451-02 Rev. 1 (05-2021)
Copyright
2021 Christie Digital Systems USA, Inc. All rights reserved.
©
Turn to adjust height.
C
15
Advertisement
