Advertisement
Connect the projector and chiller to the power source.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! A dedicated, protected ground or earth wire must be installed on the product by
Christie qualified technicians or electricians before it can be connected to power.
•
SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
•
FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
•
SHOCK HAZARD! The AC power cord must be inserted into an outlet with grounding.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage and
current, as specified on the license label.
•
SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
•
The appliance coupler and main power supply plug must be easily accessible for disconnecting the
product from the power source.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Only Christie qualified technicians are permitted to open product enclosures.
•
Install the product near an easily accessible AC receptacle.
•
For products containing surge suppressors, you must adhere to the installation and power
requirements.
1. If the projector is operating, turn it off and disconnect it from AC power.
2. Loosen the threaded bolt on the ground lug on the AC receptacle on the rear of the projector.
3. Remove 15 mm of insulated covering from both ends of the protected earth wire.
4. Insert a bare end of the protected earth wire into the hole on the top of the ground lug so it is
beneath the threaded bolt.
5. Tighten the threaded bolt to 50 in-lb.
6. Connect the other bare end of the protected earth wire to the building ground.
7. Connect one end of the projector power cord to the AC receptacle on the lower-left rear corner of the
projector and then connect the other end of the power cord to an AC receptacle.
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe Installation and Setup Guide
020-103451-02 Rev. 1 (05-2021)
Copyright
2021 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
22
Advertisement
