Advertisement
6. With the assistance of another person, lift the second projector and position it on top of the bottom
projector so each of its feet fit into a stacking cup. The lenses of both projectors must face the same
direction and the optical axis of both projector lenses must be parallel (A) and align vertically (B).
7. Install both projectors.
a. Install the touch panel (on page 15).
b. Install the lens (on page 16).
c.
Install the lamp (on page 18).
d. Connect devices to the projector (on page 23).
e. Connect power (on page 20).
f.
Adjust the bottom projector image to fit the screen. For more information, see the CP2306-
RGBe, CP2308-RGBe, CP2310-RGBe User Manual.
g. Align the top projector image to the bottom projector image. For more information, see the
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe User Manual.
8. When both projectors are installed and aligned correctly, install the locking brackets on the feet of the
top projector.
a. Slide the locking bracket (011-104470-XX) over the flat sides of the stacking cup, so the notch
in the locking bracket fits around the projector leg and above projector foot nut.
b. Turn the locking bracket so the flanges of the locking bracket fit tightly below the stacking cup
tabs.
c.
Repeat steps a and b to install the three remaining locking brackets
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe Installation and Setup Guide
020-103451-02 Rev. 1 (05-2021)
Copyright
2021 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
18
Advertisement
