Electrical system
TABLE M2 - OIL PRESSURE SENSOR
•
The wiring (1) of the oil pressure sen-
sor must pass behind the pipe fitting of
the cooling system and after connect-
ing the connector to the sensor, lock
the wiring with a clamp (5) as indicated.
TABLE N - QUICK SHIFT
•
The wiring (1) of the quick shift (2) must
pass through the special groove in the
sprocket cover as shown and behind
the gear lever.
TABLE N1 - QUICK SHIFT
•
The wiring (1) of the quick shift must
pass through the internal part of the
frame/seat sub-frame and then the
connector, located inside the compart-
ment under the saddle on the right
side, must be connected.
ELE SYS - 104
RS 660 - Tuono 660