Panel Programming/Operation; Program Mode; Programming Presets; Programming Ramping Presets - AMX PRO-DP8 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

Panel Programming/Operation

Program Mode

The panel must be in Program mode in order to do any programming. To enter Program mode, DIP
switch 8 must be set to Off (its default setting).
To enter Program mode, press the Up and Down buttons (pushbuttons 6 and 7) simultaneously for 2
seconds. The P LED on the front of the panel lights to indicate that Program mode is active.
If you make a mistake, or decide not to record changes, press the Up/Down buttons again to cancel
Program mode.

Programming Presets

The number of Presets available to program depends on the setting of DIP switch 7.
If DIP switch 7 is set to Off (Default mode), pushbuttons 1-4 are available as Preset buttons, and
pushbuttons 5-8 are used for other panel functions (i.e. Select, Up/Down, and Off.
If DIP switch 7 is set to On (Preset Recall mode), all pushbuttons (1-8) are available as Preset
buttons. Refer to the DIP Switch Configuration section on page 15 for details.
1. Ramp all active channels to 0 using the Select (pushbutton 5) and Up/Down buttons
(pushbuttons 6 and 7). Alternatively, you can use the Off button to turn all lights off.
2. Use the Select button to select a zone and then use the Up/Down buttons to ramp the light to
the desired level. Repeat this for all zones to set all lights to the desired level.
3. Enter Program mode by pressing the Up and Down buttons simultaneously for 2 seconds
(Program mode is indicated by the P LED).
4. Press the Preset button where the new preset will be stored. The length of time that you hold
the button down determines the ramp speed.
5. Repeat the preceding steps as required for other Presets.

Programming Ramping Presets

1. To enter Ramping Preset mode, press and hold the desired Preset button for 2 seconds.
Ramping Preset mode is indicated by the Up/Down button LEDs (lit simultaneously).
2. Press the Up and Down buttons (pushbuttons 6 and 7) to ramp the light level for the selected
Preset as needed.
3. Release the Preset button to stop ramping. Preset Ramping mode quits after 6 seconds.
4. Repeat the preceding steps as required for other Presets.
PRO-DP8 Decor 8-Button Wall Panel
Panel Programming/Operation
19