Hyundai 250D-9 Manual page 202

4) 4) LAMP BULBS REPLACEMENT LAMP BULBS REPLACEMENT
Lamp
Head lamp(up)
Head lamp(down)
Turn signal lamp
Clearance lamp
Stop lamp
Backup lamp
License lamp (option)
Beacon lamp (option)
Rear work lamp
After checking that the fuse is not blown and that there is no disconnection in the wiring After checking that the fuse is not blown and that there is no disconnection in the wiring
harness, replace the lamp bulb. harness, replace the lamp bulb.
5) 5) FUNCTIONAL TESTS FUNCTIONAL TESTS
You will start the engine to complete the functional tests, so be sure that:
·The parking brake is applied.
·The gear selector lever is in NEUTRAL.
·Forks are fully lowered to the floor or ground.
· All controls are in neutral or other correct position.
· You are familiar with the safety procedures given in section 5. Starting and operating
procedures, procedures, in this manual.
As you test the following components, be sure they are properly mounted and working correctly.
(1) (1) Horn Horn
Press the horn button to check horn function. If the horn or any other part does not operate,
report the failure and have it repaired before the truck is put into operation.
(2) (2)
Hour meter Hour meter
Start the engine and let it warm up until it runs evenly and accelerates smoothly when you push
on the accelerator pedal. Check the hour meter for operation with the engine running. Write the
hour meter reading on the PM report form. Report any malfunction or damage.
(3) (3) Indicator lights Indicator lights
Check that all lights are functioning and indicate normal truck operation as described in section 3,
Know your truck, in this manual. Know your truck,
(4) (4) Service brakes and inching pedal Service brakes and inching pedal
With the gear selector lever in NEUTRAL and the engine running, push the service brake pedal
fully down and hold. The brakes should apply before the pedal reaches the floorplate. If the
pedal continues to creep downward, report the failure immediately. Do not operate the truck until
the brakes are repaired. Perform the same check with the inching pedal. (Additional braking/
inching checks will follow).
Spec (24V)
65W
70W
LED
LED
LED
LED
10W
Strobe type
65W
7-53
160D7EOM69
Starting and operating