Hyundai 250D-9 Manual page 165

7. REPLACEMENT AND CHECK 7. REPLACEMENT AND CHECK
1) 1) CHECK ENGINE OIL LEVEL CHECK ENGINE OIL LEVEL
Check the oil level with the machine on a flat
ground before starting engine.
(1) Pull out the dipstick and wipe with a clean cloth.
(2) Check the oil level by inserting the dipstick
completely into the hole and pulling out again.
(3)
If oil level is LOW, add oil and then check again.
※
If the oil is contaminated or diluted, change If the oil is contaminated or diluted, change
the oil regardless of the regular change the oil regardless of the regular change
interval. interval.
※
Check oil level after engine has been stopped Check oil level after engine has been stopped
for 15 minutes. for 15 minutes.
Do not operate unless the oil level is in the Do not operate unless the oil level is in the
normal range. normal range.
2) 2) REPLACEMENT OF ENGINE OIL AND OIL REPLACEMENT OF ENGINE OIL AND OIL
FILTER FILTER
(1)
Operate the engine until the coolant temperature
reaches 60°C (140°F). Shut off the engine.
(2) Remove the plug and allow the oil to drain.
· Wrench size : 27 mm
※
A drain pan with a capacity of 30 liters (6.6 A drain pan with a capacity of 30 liters (6.6
U.S.gallons) will be adequate. U.S.gallons) will be adequate.
(3) Clean the area around the oil filter head.
(4) Use oil filter wrench to remove the oil filter.
(5)
Clean the gasket surface of oil filter head.
※
The O-ring can stick on the filter head; make The O-ring can stick on the filter head; make
sure it is removed before installing the new sure it is removed before installing the new
filter. filter.
plug
7-19
Engine oil fill
Normal
Dipstick
250D9MI01
Drain pan
250D9MI02
180D7EMI03