Shut Down Procedure - Hyundai 250D-9 Manual

13. SHUT DOWN PROCEDURE

13. SHUT DOWN PROCEDURE
※
Always leave your lift truck in a safe condition. Always leave your lift truck in a safe condition.
1) 1) WHEN YOU LEAVE YOUR TRUCK, OR PARK IT, FOLLOW THESE SAFETY RULES WHEN YOU LEAVE YOUR TRUCK, OR PARK IT, FOLLOW THESE SAFETY RULES
(1) Park in a safe area away from normal traffic.
(2) Never park on a grade or a slope.
(3) Never park in areas that block emergency routes or equipment, access to fire aisles, or stairways
and fire equipment.
2) 2) BEFORE LEAVING THE OPERATOR'S POSITION BEFORE LEAVING THE OPERATOR'S POSITION
(1) Bring the truck to a complete stop.
(2) Put the gear selector lever in the NEUTRAL position.
(3) Press parking brake switch ON.
(4) Lower the lifting mechanism-carriage and forks or attachment fully to the ground.
3) 3) IN ADDITION, WHEN LEAVING THE TRUCK IN ADDITION, WHEN LEAVING THE TRUCK
UNATTENDED UNATTENDED
(1) Tilt the mast forward until the forks are level and
flat on the ground. Let the engine run at idle
speed.
(2) Turn the start switch to the OFF position and
remove the key.
(3) Block the wheels, if the truck must be left on an
incline or you have any doubt about the truck
moving from a safe position.
※
If the lift truck has been working hard, let the If the lift truck has been working hard, let the
engine idle a few minutes before shutting it engine idle a few minutes before shutting it
off. off.
CAUTION FOR TURBOCHARGER PROTECTION CAUTION FOR TURBOCHARGER PROTECTION
In order to prevent turbocharger failure, please In order to prevent turbocharger failure, please
let the engine idle for more than 5 minutes let the engine idle for more than 5 minutes
before shutting it off. before shutting it off.
Parking brake switch ON
Forks are
down
5-31
ON
Parking switch ON
250D9OM31-1
Low idling for
5 minutes
250D9OP07