Hyundai 250D-9 Manual page 146

To ground
Charged battery
- +
b
Jumper
cable
c
- +
Eng
block or
frame
Dead battery
To ground
To starter switch
- +
a
a
- +
To starter switch
D35AOM146
6-4
5) Connect the jumper cables in the following
sequence:
ⓐ Connect a jumper cable from the positive
(+; red) terminal on one battery to the
positive (+; red) terminal on the other
battery. Never connect positive (+; red) to
negative (-; black), or negative to positive.
ⓑ Connect one end of the second cable to
the grounded negative (-; black) terminal
of the jumper vehicle umper vehicle battery.
ⓒ Connect the other end of the second
cable to a stationary, solid metallic point
on the engine of the stalled vehicle
to the negative (-; black) terminal of its
battery. Make this connection at a point
at least 450 mm (18 in) away from the
battery, if possible. Do not connect it to
pulleys, fans or other parts that move. Do
not touch hot manifolds that can cause
sever burns.
6) Start the engine on the jumper vehicle
run the engine at a moderate speed for a
minimum of five minutes.
7) Start the engine on the stalled vehicle.
Follow the starting instructions in section 5,
starting and operating procedures tarting and operating procedures in this
manual. Be sure that the engine is at idle
speed before disconnecting the jumper
cables.
8) Remove the jumper cables by reversing the
installation sequence exactly. Start by
removing the last jumper cable from the
stalled vehicle first. Remove the cable end
from the engine block first, then the other end
of the negative (-; black) cable.
9) Remove both ends of the positive (+; red)
cable.
talled vehicle, not
umper vehicle and
talled vehicle.