Hyundai 250D-9 Manual page 183

17) 17) LEAKAGE OF FUEL LEAKAGE OF FUEL
Be careful and clean the fuel hose, injection Be careful and clean the fuel hose, injection
pump, fuel filter and other connections as the pump, fuel filter and other connections as the
leakage from these part can cause fire. leakage from these part can cause fire.
18) 18) HYDRAULIC OIL CHECK HYDRAULIC OIL CHECK
(1)
Lower the forks on the ground at a flat location
as in the illustration.
Stop the engine and then leave for about 5
minutes.
(2)
Check the oil level at the level gauge. The level
gauge is located on the left side of the hydraulic
oil tank.
(3)
The sight gauge should indicate the middle
position (between red lines).
※
Add hydraulic oil, if necessary. Add hydraulic oil, if necessary.
※
Refer to the page 5-6 for details. Refer to the page 5-6 for details.
19) 19) FILLING HYDRAULIC OIL FILLING HYDRAULIC OIL
(1) Stop the engine to the position of level check.
(2) Check air breather filter and replace it if
necessary.
(3) Loosen cap and fill the oil to the specified level.
(4) Start engine after filling and operate the work
equipment several times.
(5) Check the oil level at the level check position
after engine stops.
FIRE !!!
Red line
7-35
250D9MI16
Level gauge
250D9MI21
Air breather
Air breather
Element
Bolt
250D9MA18