Hyundai 250D-9 Manual page 13

11) 11) OPERATOR SAFETY (item 11) OPERATOR SAFETY
This warning label is positioned on the front
left stay of the cabin inside.
(1)
Refer to operator's manual in detail.
(2)
Always buckle up the seat belt for safety
operation.
(3)
When the operator get off the machine,
always turn the parking brake switch ON
position so that the truck can keep with
stopping condition.
(4)
The people should not pass through under
forks and other attachments which are
lifted or being lifted.
(5)
Do not jump down from the machine. It
can be caused that the operator have
severe injury or death in the event of a tip
over.
(6)
Outstretch the legs as widely as possible
and grasp firmly the steering handle.
(7)
Lean the body to the opposite direction in
order to avoid severe injury or death when
the truck is tipped over.
※
Refer to page 3-3 for details. Refer to page 3-3 for details.
12) 12) START PROCEDURE START PROCEDURE (item 28)
This warning label is located on the right
window of the cabin inside.
(1) The fuel transfer pump is self-priming.
When the keyswitch is in ON position, the
fuel transfer pump operates for 30
seconds and then shuts off.
①
This fuel lift pump automatically forces
the air out of the low pressure side of the
fuel system from the air bleed fitting to
fuel return line.
②
This feature can be used to check the
operation of lift pump and to fill the low
pressure side fuel system after the
services.
③
Air grid heater operates depending on ambient temperature.
(2)
Wait until the self-priming is completed.
(3)
Start cranking.
If necessary or the engine would not start, 30 seconds lift pump cycle can be repeated until air is
purged from low pressure side of fuel system.
(4)
Re-cranking.
(5)
If the engine still would not start, please contact the nearest HYUNDAI or Cummins dealers.
Start Procedure Start Procedure
1.The fuel transfer pump is self-priming.
When the Keyswitch is in ON position, the fuel transfer pump
operates for 30 seconds & then shuts off.
. This fuel lift pump automatically forces the air out of the low
pressure side of the fuel system from the air bleed fitting
to fuel return line.
. This feature can be used to check the operation of lift pump
and to fill the low pressure side fuel system after the services.
. Air grid heater operates depending on ambient temperature.
2. Wait until the self-priming is completed.
3. Start cranking.
If necessary or the engine would not start, 30 seconds lift
pump cycle can be repeated until air is purged from low
pressure side of fuel system.
4. Re-cranking.
5. If the engine still would not start,
please contact the nearest HYUNDAI or Cummins dealers.
0-10
1
2
3
4
5
6
7
25L7AOM09-1
91LB-11170