Hyundai 250D-9 Manual page 152

2) 2) PRECAUTION PRECAUTION
(1)
Start maintenance after you have the full knowledge of the truck.
(2) The monitor installed on this truck does not entirely guarantee the condition of the truck.
Daily inspection should be performed according to maintenance.
(3)
Engine and hydraulic components have been preset in the factory.
Do not allow unauthorized personnel to reset them.
(4)
Ask to your local dealer or Hyundai for maintenance advise it unknown.
(5) Drain the used oil and coolant in a container and handle according to the method of handling for
industrial waste to meet with regulations of each province or country.
3) 3)
PROPER MAINTENANCE PROPER MAINTENANCE
(1) Replace and repair of parts
It is required to replace the wearable and consumable parts such as hose, tube and filter etc.,
regularly. Replaced damaged or worn parts at proper time to keep the performance of the truck.
(2)
Use Hyundai genuine parts.
(3) Use the recommended oil.
(4)
Remove the dust or water around the inlet of oil tank before supplying oil.
(5)
Drain oil when the temperature of oil is warm.
(6)
Do not repair anything while operating the engine.
(7)
Stop the engine when you fill the oil.
(8) Relieve hydraulic system of the pressure by opening of breather when repairing the hydraulic
system.
(9)
Confirm if the cluster is in the normal condition after completion of service.
(10) For more detail information of maintenance, please contact local Hyundai dealer.
※
Be sure to start the maintenance after fully understanding the section 1, safety hints. Be sure to start the maintenance after fully understanding the section 1, safety hints.
4) 4) PRECAUTION WHEN INSTALLING HYDRAULIC HOSES OR PIPE PRECAUTION WHEN INSTALLING HYDRAULIC HOSES OR PIPE.
(1) Be particularly careful that joint of hose, pipe and functioning item are not damaged.
Avoid contamination.
(2)
Assemble after cleaning the hose, pipe and joint of function item.
(3) Use Hyundai genuine parts.
(4) Do not assemble the hose in the condition of twisted or sharp radius.
(5) Keep the specified tighten torque.
7-6