Starting And Stopping The Engine - Hyundai 250D-9 Manual

7. STARTING AND STOPPING THE ENGINE

7. STARTING AND STOPPING THE ENGINE
1) 1) CHECK INDICATOR LIGHTS CHECK INDICATOR LIGHTS
(1) Check if the parking brake switch is ON.
(2) Check if the gear selector lever is in neutral
position.
(3) Turn the key to the ON position, and check
following.
①
If all the lamps light ON after sounding buzzer
for 3 seconds.
※
If the lamps do not light or the buzzer is not If the lamps do not light or the buzzer is not
sounded, check disconnection of wire. sounded, check disconnection of wire.
②
Only below lamps will light ON and all the other
light will be turned OFF after 3 seconds.
- Charging warning lamp (1)
- Engine oil pressure warning lamp (2)
- Brake fail warning lamp (3)
※
Start the engine after all of the lamps OFF. Start the engine after all of the lamps OFF.
(Only above 3 lamps remain ON) (Only above 3 lamps remain ON)
2) 2) STARTING ENGINE IN NORMAL TEMPER- STARTING ENGINE IN NORMAL TEMPER-
ATURE ATURE
※
Sound the horn to warn the surroundings after Sound the horn to warn the surroundings after
checking if personnel or obstacles are in the checking if personnel or obstacles are in the
area. area.
(1) Turn the starting switch to START position to
start the engine.
※
If the engine does not start, allow the starter If the engine does not start, allow the starter
to cool for about 2 minutes before attempting to cool for about 2 minutes before attempting
to start the engine again. to start the engine again.
(2) Release the starting switch instantly after the
engine starts to avoid possible damage to the
starting motor.
(2) The starting switch will automatically return to
the ON position.
Gear selector lever
1
START START
5-11
Parking brake switch
2 3
180D9OP04
ON ON OFF OFF
77074OP04