Printing - Simple Mode - SINTERIT LISA PRO User Manual

8. Printing - simple mode

1. Check whether the Safety button (red button on the right
side of the printer)
10
of the button clockwise at a quarter of a turn.
2. Turn on the printer. Switch the Power switch
"1" and turn the Ignition key in the Key slot
a quarter of a turn.
3. Please wait until the main menu with four buttons appears
on the LCD screen (it takes about 20 seconds).
4. Attention, Electrolock! To open the printer's Lid
The magnetic blockade deactivates for 10 seconds. After 10 seconds, it will re-activate.
5. Softly press the Lid and then lift it using Lid's handle
Be careful! The Lid is quite heavy!
6. Check that all components are in place, ready to be filled with powder.
ATTENTION!
•
Before starting any work with powder, always wear adequate protective clothing,
eyewear, face mask, and gloves.
•
A suitable set is included in the DEDICATED POWDER TOOLS for Lisa PRO printer as
PERSONAL PROTECTION kit.
CAUTION!
Beware of sharp edges, especially on the Lid.
IMPORTANT!
•
The system will guide you step by step through the printing process.
•
Please read the messages on the LCD screen carefully. Skipping the described
operations may result in incorrect printing or machine failure.
•
The BACK button takes you back to the previous screen (if you missed something by
accident or want to take a step again).
IMPORTANT!
•
For the first use of the Sinterit Lisa PRO printer with PA12 Smooth or PA11 Onyx, please
use only the powder from the container labelled STARTER POWDER.
•
The process of mixing powders will be described in a separate chapter.
is out. If not, rotate the black flange
from "0" to
15
clockwise at
9
5
Unlocking and turning on the printer.
press START NEW PRINT/UNLOCK LID button on the screen
.
6
9
10
15
Sinterit LISA PRO User Manual | 25
.
2