Last Steps Before Start Printing - SINTERIT LISA PRO User Manual

4. WI-FI ACTIVATION
The highlighted Wi-Fi icon in the
upper left corner means a network
connection.
Press the BACK button to return to the
main menu screen.
D. LAST STEPS BEFORE START PRINTING
1. CHECK FIXING THE SHORT
INFRARED HEATERS IN
SOCKETS
Check (wearing gloves or through
the paper) whether the Short Infrared
Heaters are stable in their sockets (8
pcs.).
If there is any dust/powder on them,
blow it gently off with air.
ATTENTION!
Remember, do not touch the Short Infrared heaters with your fingers or greasy objects (eg. a dirty
cloth).
Dirt and grease may cause local overheating and burn the heaters or even cause an explosion
during printing.
2. CHECK THE ELEMENTS IN
THE PRINT CHAMBER
Verify whether the Feed Bed
Print Bed are ready to work (after
29
unpacking the BEDs should be on
par with the printer's case), check the
Recoater's cords , tension and
25 27
whether the Recoater's guide bar
clean.
After carrying out all of these steps, the printer is prepared to work.
The sign in the upper left corner of the screen shows active Wi-Fi.
Methods of verifying the correct seating of Short Infrared Heaters.
and
28
is
26
FUBAR
RELIVE
TP-LINK_EABF45
ISTS_TP_LINK_86B16D
OR
25
26
27
28
29
30
Check the parts in the Printing Chamber.
Sinterit LISA PRO User Manual | 23