SINTERIT LISA PRO User Manual page 13

2. UNLOCK THE LOCKS OF THE
FLIGHTCASE COVER
Unlock 4 locks on the lower part of the
the Flightcase cover (2 on the front
E
and 2 on the back).
Turn the lock handle by 90 degrees
. Rotate the lock handle approx.
b
225 (180 + 45) degrees CCW until the
hook opens . Repeat on each of the
c
four locks of the Flightcase cover.
3. OPEN THE FLIGHTCASE
Carefully grab the handles of the cover
on both sides of the the Flightcase
D
(two people needed) and lift it to
a height of minimum one meter.
Be careful, not to snag the printer!
Place the cover in a safe and stable
place. Remove all foils from the
outside of the printer. Make sure that
the Lisa PRO hasn't been damaged
during the transport. Check against
any visible signs of it.
4. MOVE THE PRINTER FROM
THE FLIGHTCASE TO THE
TARGET WORKSTATION
Grab the printer holders
(see picture for front and back),
LIFT
HERE
carefully lift it up and place it on a
stable surface. We recommend the
target workstation.
Ensure that the printer is placed in a
location where its size and weight will
be properly supported.
IMPORTANT!
Remember to register your printer and activate your software at sinterit.com/register
The registration gives you the fastest possible access to software updates, support tips and expert
knowledge from our specialists.
,
a
Correct lift of the cover from Lisa's PRO Flightcase.
,
4 17
Correct lift of Lisa PRO from the Flightcase.
a
Unlocking the lock of a Flightcase's cover.
b c
Sinterit LISA PRO User Manual | 13