SINTERIT LISA PRO User Manual page 41

View of the Print Chamber after the positioning of Beds and Recoater - Feed Bed cleaning process.
5. Transfer all powder from Feed Bed to Print Bed.
6. Clean the space around the Beds and press the DONE
button. Use a spatula and brush to thoroughly clean the
space, especially under the Recoater guide bar.
7. Press the CLEAN PRINT BED screen to start the Print Bed
cleaning process.
• If it is clean you can skip this step by pressing the PRINT
BED ALREADY CLEANED.
8. Check that the way of the Recoater is not obstructed and
press the DONE button.
9. The positioning of the Recoater and the Beds will start. The
Recoater will go to the Feed Bed side and then the Print Bed
will move up to the top.
Cleaning the Print Bed
Make sure that the path of the Recoater
is not obstructed
BACK
CLEANING STEP 7/10
Check the Recoater's path.
DONE
the Beds and Recoater - Print Bed cleaning process.
Cleaning the Feed Bed
Clean area around the Feed Bed
Put the remaining powder into
the Print Bed
BACK
CLEANING STEP 5/8
The screen of the cleaning Feed Bed.
Cleaning the Print Bed
You can skip this step it the Print Bed
is clean
PRINT BED ALREADY CLEANED
BACK
CLEANING STEP 7/10
Screen initiating the cleaning process
of the Feed Bed.
View of the Print Chamber after the positioning of
DONE
CLEAN FEED BED
Sinterit LISA PRO User Manual | 41