Setting Up Electronic Image Stabilization (Eis) - American Dynamics SpeedDome Ultra 8 Operator's Manual

5. If you have selected Open Shutter and need to change the shutter limit setting, continue
below. Otherwise, continue with step 7.
6. Move the highlight to the Limit field. Change the setting. The following settings are
available:
•
For NTSC cameras, the setting values range from 1/2 to 1/60.
• For PAL cameras, the setting values range from 2/3 to 1/50.
The default setting is 1/4 for NTSC and 1/3 for PAL.
7. Select Exit. The Dome Configuration Menu appears.

Setting Up Electronic Image Stabilization (EIS)

You can turn off EIS or adjust the EIS sensitivity level for 35X cameras on your system
through the Camera Functions screen.
Follow the steps below:
1. Access the Dome Configuration Menu (Figure 26) by pressing Iris Open, Focus Far,
and Zoom Out on your controller.
2. Use the joystick to highlight Camera Functions and press Focus Far to select. The
Camera Functions screen (Figure 27) appears.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Note: The EIS feature is only available on 35X camera domes.
Figure 26. Dome Configuration Menu
DOME CONFIGURATION MENU
PAN/TILT/ZOOM/SYNC OPTS
CAMERA FUNCTIONS
ALARMS/AREAS/HOME/PRESETS/PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES
36 of 140
8200-0600-01, REV. B