Chapter 2: Configuring Pan, Tilt, Zoom, And Synchronization Options; Setting The Automatic "Flip" Feature - American Dynamics SpeedDome Ultra 8 Operator's Manual

Chapter 2: Configuring Pan, Tilt, Zoom, and Synchronization
Options
This chapter describes the use of the Pan/Tilt/Zoom/Sync Opts menu. Use this screen to set
the Auto Flip feature, configure the Zoom Stop settings, set the Line Lock option, and configure
the Freeze Frame setting.
When Pan/Tilt/Zoom/Sync Opts is selected from the Dome Configuration Menu, the
following screen appears:
Use this screen to enable or disable the "automatic flip" feature, configure the zoom stop
settings, and set the line lock options.
•
To change the settings, move the highlight bar to appropriate field and make the changes.
• To change the settings for this screen to the factory defaults, select Reset to Factory
Settings.
•
To return to the Dome Configuration Menu, select Exit.

Setting the Automatic "Flip" Feature

Use the automatic (proportional) "flip" feature when you need to track someone who walks
directly under the dome and continues on the other side. You start the flip by moving the tilt
control to its lower limit and holding for a brief period. When the flip engages, the dome
automatically rotates 180°. You may then continue to track the person as long as the tilt control
stays in its lower limit. Once the tilt control is released, the dome resumes normal operation.
The dome is initially installed with the automatic flip feature disabled. In this situation, the
dome stops when the tilt down reaches its lower limit.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Figure 11. Pan/Tilt/Zoom/Sync Options screen
PAN/TILT/ZOOM/SYNC OPTS
PROPORTIONAL FLIP
1ST ZOOM STOP X
MAX TOTAL ZOOM X
LINE LOCK
FREEZE FRAME
RETURN TO AUTO
RESET TO FACTORY SETTINGS
EXIT
19 of 140
OFF
35
420
OFF
OFF
8200-0600-01, REV. B