Working With The Dome Configuration Utility - American Dynamics SpeedDome Ultra 8 Operator's Manual

The following menu appears on the monitor:
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7

Working with the Dome Configuration Utility

Once the Dome Configuration Menu is displayed, you can select a menu item, and then
modify the settings you want to change. The following table summarizes the controller
commands for SensorNet, RS-422, and Manchester protocols. For combination keystrokes,
press and hold each button in sequence, then release.
If you want to ...
Move the highlight bar.
Select the highlighted item on the screen.
Increase the value of the selected setting or display the next
choice for the setting
Decrease the value of the selected field, or display the
previous choice for the field.
During naming, move the cursor to the right of the current
character in the name.
During naming, move the cursor to the left of the current
character in the name.
Save changes and exit the utility from any screen.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Figure 1. Dome Configuration Menu
DOME CONFIGURATION MENU
PAN/TILT/ZOOM/SYNC OPTS
CAMERA FUNCTIONS
ALARMS/AREAS/HOME/PRESETS/PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES
I M P O R T A N T
If you have password protection enabled for the configuration utility, the Enter
Password screen appears first. You must correctly enter the password before the
Dome Configuration Menu will appear. For information about entering the
password, refer to Entering the Dome's Password on page 11.
Table 1. Controller commands
10 of 140
Chapter 1
Use ...
Pan/Tilt
Focus
Zoom In
Zoom Out
Zoom In
Zoom Out
Iris Close, then Focus
8200-0600-01, REV. B