American Dynamics SpeedDome Ultra 8 Operator's Manual page 71

Additional Dome Commands
Table 9 provides the special commands available when using the dome in an AD-UTC
network. These commands are available when you enter the keyboard combination provided.
Command
F
(1-96), and then
Preset # (1-96), and then
(Preset)
F
and then
(Shift+Preset)
Pattern # (1-3), and then
(Function)
Pattern # (1-3), and then
+
F
(1-3), then
move joystick as desired, enter
Pattern number, and then
(Function)
F
(1-3), then
then
F
(1-3), then
move joystick as desired, and
then
F
(1-3), then
then
F
Far)
F
Near)
F
(Function+Iris Open)
F
(Function+Iris Close)
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Table 9. Additional dome commands
Function
Program selected Preset
(Function), Preset #
(Preset)
Recall selected Preset
(Ver. 0.20 keyboard only) Start selected Pattern programming
(Function), pattern # (1-3),
+
(Ver. 0.20 keyboard only) Save Pattern programming
F
(Ver. 0.20 keyboard only) Run selected Pattern continuously
(Shift and Preset)
(Ver. 1.0 keyboard only) Program a Pattern in RS-485 mode
(Function), pattern #
(Pattern),
F
(Ver. 1.0 keyboard only) Delete a Pattern in RS-485 mode
(Function), pattern #
(Pattern), and
F (Function)
(Ver. 1.0 keyboard only) Program a Pattern in RS-232 mode
(Function), pattern #
(Pattern),
(Pattern)
(Ver. 1.0 keyboard only) Delete a Pattern in RS-232 mode
(Function), pattern #
(Pattern), and
(Pattern)
Resume Auto Focus mode
+ (Function+Focus
Or
+ (Function+Focus
Resume Auto Iris mode
+
Or
+
Rotate dome 180° from current position ("flip")
(Flip)
69 of 140
8200-0600-01, REV. B