American Dynamics SpeedDome Ultra 8 Operator's Manual page 112

Activating Auto Scan
Auto Scan allows the dome to continuously pan between the left and right scan limit settings.
When reaching the right scan limit, the direction is automatically reversed. If no scan limit
settings are programmed, the dome pans to the right continuously.
To activate the Auto Scan:
1. Select the camera number assigned to the dome.
2. Enter Go To Preset 99.
The Auto Scan runs until stopped by selecting the camera and entering Call Preset 96.
Activating Frame Scan
Frame Scan pans between the left and right scan limits, pausing briefly (3 seconds) at each
frame. A frame is equivalent to approximately 10° when the zoom setting is 1X. If the scan
limits are not programmed, the Frame Scan pans to the right, pausing at each frame.
To activate the Frame Scan:
1. Select the camera number assigned to the SpeedDome Ultra 8 camera dome.
2. Enter Call Preset 98.
The Frame Scan runs until stopped by selecting the camera and entering Call Preset 96.
Activating Random Scan
Random Scan pans between the left and right scan limits for random periods between 1 and 9
seconds, then pauses for periods between 1 and 9 seconds. If the scan limits are not
programmed, the Random Scan pans to the right for random periods between 1 and 9 seconds,
then pauses for periods between 1 and 9 seconds.
To activate the Random Scan:
1. Select the camera number assigned to the SpeedDome Ultra 8 camera dome.
2. Enter Call Preset 97.
The Random Scan runs until stopped by selecting the camera and entering Call Preset 96.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Note: Entering a pan/tilt or lens command also stops the scan.
Note: Entering a pan/tilt or lens command also stops the scan.
Note: Entering a pan/tilt or lens command also stops the scan.
110 of 140
8200-0600-01, REV. B