Setting The Dome Address; Dome Maintenance; Changing Special Features - American Dynamics SpeedDome Ultra Camera Installation And Service Manual

Dome Maintenance

Updating/Reprogramming
Dome Software
To update or reprogram dome software:
1. Remove the flash memory chip.
Insert the chip extractor tool into the square access
hole and squeeze to extract the flash memory chip
(Figure Chapter 4-19).
CAUTION—ELECTROSTATIC
SENSITIVE DEVICE! Use a grounding
strap when handling chip.
2. Reprogram the chip or replace it with a new
chip.
3. Reinsert the chip.
Align the dot on the chip with the indent on the
socket, then push down on the chip to reinsert it.
Figure Chapter 4-19

Setting the Dome Address

Recessed at the top of the dome assembly are
three rotary switches (Figure Chapter 4-20) which
enable the dome address to be changed from 001
to 255.
Figure Chapter 4-20

Changing Special Features

The three rotary switches (Figure Chapter 4-20)
also enable special features to be enabled or
disabled. To change enable/disable these features:
1. Enable/Disable the feature.
Remove the dome from its base, set the switches to
enable/disable the feature, then reattach the dome to
enter your settings.
911
912
918
919
920
921
922
923
2. Reset the address previously entered.
Remove the dome again to set the address
previously entered, then reattach it. The dome
should then begin its homing routine.
SPEEDDOME ULTRA
4-11
SW3
SW2 SW1
MSB
LSB
0 9 0 9 0 9
Pan motor planetary gear
Pan motor spur gear
Enable AGC
Disable AGC
Enable line lock
Disable line lock
Alarm contacts normally open
Alarm contacts normally closed
SERVICE